Follow these steps to verify your ETH or USDC deposit with Rabby Wallet and a Trezor. You show that the wallet you sent from is yours by signing a short message. EU rules require exchanges to know who sends and receives crypto transfers. No funds move when you sign.
What you need
- Rabby Wallet, the wallet you sent the deposit from
- Your Trezor, connected and unlocked
Open the deposit in NBX
Step 1: Open the pending deposit
Go to Funds → Deposits in the NBX app. Your incoming ETH or USDC transaction is listed with the status Incomplete. Click it to open the form where you confirm who sent it.
Step 2: Check the Verify the sender screen
An Add Funds panel opens with the form Verify the sender. The form comes from Notabene, a service we use for this. It has four sections:
- Amount: the deposit amount (filled in for you)
- Source: the sending wallet address (filled in for you)
- Sender: who is sending the funds
- Wallet: the wallet used to sign and confirm ownership
You only need to complete Sender and Wallet.
Confirm who sent it
Step 3: Choose the sender type
Under Sender, choose:
- Myself if you own the sending wallet
- Another individual if someone else is sending
- A business or organization for company transactions
In most cases, choose Myself.
Step 4: Choose Rabby Wallet
Open the Wallet section. Under Self-hosted Wallet, choose Rabby Wallet.
Note: If you use Ledger, choose Ledger USB or Ledger Bluetooth, then click Verify Ownership.
Sign with Rabby and Trezor
Step 5: Connect Rabby Wallet
A Rabby Wallet notification asks to connect to https://connect.notabene.id. Check the details and click Connect.
Step 6: Click Begin signing process
Rabby shows your wallet address and asks you to confirm the account. Click Begin signing process.
Step 7: Confirm on your Trezor
Rabby sends the signing request to your Trezor, and you see the message Confirm on Trezor. Follow the instructions on the device and approve the request.
Note: No funds move. You are only signing a message.
Finish the verification
Step 8: Click Complete
Once signed, all sections in the form show green checkmarks. Click Complete.
Done. You see a confirmation message. Your deposit is credited once the blockchain transaction is confirmed.
If something doesn't work
- The signing request doesn't appear. Check that your Trezor is connected, unlocked and active.
- The deposit still shows Incomplete. Refresh the page and try again.
- My wallet isn't listed. Use Connect another device.
- I use Ledger. Choose the correct connection type and approve on your device.
- I'm stuck. Contact support.